Jump to content
DanishMan

Skiving machine with no scrap deflector

Recommended Posts

Dear Friends

Two months ago I bought an old skiving machine. Typical old Fortuna like machine

I am a bit puzzled, that the machine has no scrap deflector. There is a tiny hole (5-6 mm) in the knife shaft with no threads - I have several scrap deflectors of both the common types, but neither fit.

Are there skiving machines, that were born with no scrap deflector?

Brgds

Danishman

Share this post


Link to post
Share on other sites

The smooth center hole is to receive the ejector. Ejector has a threaded hole, used to install and position it with a tool

https://campbell-randall.com/product/fav-322-scrap-ejector-press-fit

Edited by CampbellRandall

Share this post


Link to post
Share on other sites

Hi Campbell Randall

The center hole in this machine is too small for that. May be it needs some kind of plastic deflector.

Brgds

DanishMan

 

Share this post


Link to post
Share on other sites

5 or 6 mm would be about right for the tool, if the center had threads. Might be that the old ejector was damaged and separated from the bell. Could you post a picture of the shaft center?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...