Members seabee Posted December 10, 2019 Members Report Posted December 10, 2019 Hi, all Last night I cut out billet patterns out of red oak on a scroll saw , 2 each. Than I double sided taped leather between them. The leather was very slightly larger than the pattern. Installed a pattern bit in my rotor table, Turned the speedup high, and trimmed the leather. Came out nice with flat edges, now I will use my good leather to see how it comes out. Howard Quote
Rockoboy Posted December 10, 2019 Report Posted December 10, 2019 Sounds like you did a great there. I am always interested in results from non-standard practices. Quote Kindest regards Brian "Whether you think you can or whether you think you can't, you are right" Henry Ford Machines: Singer 201p, Kennedy, Singer 31K20, Singer 66K16 ("boat anchor" condition), Protex TY8B Cylinder Arm (Consew 227r copy), Unbranded Walking Foot (Sailrite LSV-1 copy)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.