Maths and cases (question)

[HondoMan]

On 2/7/2020 at 6:02 PM, Stetson912 said:

Well if it were me and I had to rely on math, I would do this for a starting place: 

Leather dimension = phone dimension + phone thickness+ 2x leather thickness + 2x stitch allowance + extra If needed. 

I would make the width of your case 76mm + extra (maybe 8 mm?) Total 86mm. 

Obviously this isnt exact and may vary a bit. But should get you close. The extra to add will depend on how loose the phone needs to be. 

Then do the same for the height. 

 

That being said, I would recommend making a blank. You can make one out of leather scrap too if you need too. And cardboard works well also for basic shapes like most phones. 

Thank you!  That was what I was after.....  Cheers!

Edited February 11, 2020 by HondoMan

[Stetson912]

Hope it works out for you