greystoneleatherllc Report post Posted May 25, 2020 LNKA Suspended Edge Guide #GB-6 bought a couple of these from amazon, quality seems good, will be installing on a Consew 227r and Singer 211-166 want to make sure I don't drill mounting holes in the wrong place. Also if any one knows of a mounting adapter/bracket to simplify the install and allow better positioning, see attached pictures for where I think the holes will go thanks I intended to use 1/4" 20 thread screws any feed back about hole placement welcome just want to make sure I don't drill in the wrong spots ,,db Quote Share this post Link to post Share on other sites
Uwe Report post Posted May 26, 2020 The hole positions on the Singer 211 look reasonable, but I don’t have a 211 to verify. On the Consew 227, however, your proposed hole on the right is directly in line with the presser bar - NOT a good spot! My 227 clone came with three tapped accessory holes as shown in the image below. Those are obviously good locations. Quote Share this post Link to post Share on other sites
