BrandonJones Report post Posted September 1, 2020 I just aquired a Landis 16 machine. A friend of mine uses one and he runs WD-40 in the two housings on the transmission/clutch/pulley driveshaft that is on the back of the machine, I don't know what else to call the large shaft. Are there seals on that shaft? When I fill up those housings with wd-40 it ends up slinging the oil out of the housings. Or is it supposed to have a thicker consistency oil in them? Any help would be appreciated. Quote Share this post Link to post Share on other sites
BrandonJones Report post Posted September 1, 2020 @shoepatcher Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted September 1, 2020 Just use sewing machine oil,WD-40 is NOT a good lube! Quote Share this post Link to post Share on other sites
BrandonJones Report post Posted September 1, 2020 I have some of that too!! Do you know if there are seals in there or is it going to sling it out in a nice line like the wd-40, lol. Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted September 3, 2020 Contact Eli at Landis Sales in Arthur, IL. He is the expert on that machine. glenn Quote Share this post Link to post Share on other sites
