Help! Durkopp 239 not working.

[toxo]

Yes!

Got it sewing reasonably well. . Decided to celebrate by putting on the new 250mm pulley I got the other day. Almost got it done, new belt too small by a smidgen. Never mind. Have to take a small piece out of the table and move the bobbin wiinder anyway.

Still, two pieces  of 0.9mm. I'll take that after all this time.

[Constabulary]

looks good

[toxo]

10 hours ago, Constabulary said:

looks good

Thanks Folker.

All was going well for a change but can't get a new belt 'til Monday. Me being the impetuous fool that I am will make a leather one. Can't fine tune the needle positioner 'til it's runnning properly.

I will work it out but does anyone know what the third stop plate is for on the needle positioner? The limited Chinese destructions only allude to two (Upper stop and lower stop).

The servo pulley on the 239 is 55mm and I had a spare 45mm but the bore is too big so I made a shim/bush out of a baked bean tin. Not perfect but it's working. I'll replace it when I find a better one.

My project room now looks like a bombs gone off in there. Can't wait to get some semblance of order so I can do something constructive.