Frodo Report post Posted February 5, 2022 (edited) DIY, Foot or Hand control for a servo https://www.youtube.com/shorts/ApFJMlpxnWk parts--https://www.supplyhouse.com/Copper-Riser-Clamps-13662000 https://www.supplyhouse.com/Bluefin-CPPL038-3-8-Copper... misc. 3/8'' all thread rod /nuts/washers. https://favpng.com/.../gun-slings-ruger-mini-14.../T3eUmK0M You will also need a spring. the ruger sling swivel connects the rod to the servo arm. This is a very easy build that anyone with common hand tools can make You will need a drill with a 1/2'' drill bit the rod needs to be loose and able to move as it pushes up you need a 1/4'' bolt 1'' long with locking nylon nut to hold the riser clamps, they also need to be loose I used the spring from the clamp most of us have to hold our leather, I call them chip clips The rod can be bent 90 degrees. just take your time. place 1'' of the rod into a bench vice then pull the rod slowly 90 degrees I covered my rod with a piece of copper pipe. as i scrounge more pipe i will cover the remaining rods Edited February 5, 2022 by Frodo Quote Share this post Link to post Share on other sites
chuck123wapati Report post Posted February 5, 2022 very cool !!!! Quote Share this post Link to post Share on other sites
