BDAZ Report post Posted May 31, 2014 I have a Cowboy 3200 and one of my new products requires going from a longer decorative stitch to a shorter stitch for an inch or so and then back again. What is the best way to accurately move between 2 or even 3 stitch lengths? There is no scale and it seems stitch length adjustment is pretty haphazard. Thanks! Bob Quote Share this post Link to post Share on other sites
dirtclod Report post Posted May 31, 2014 (edited) Take a pencil and mark on the outside of the adjustment slot when you get a stitch lenght you like. Edited May 31, 2014 by dirtclod Quote Share this post Link to post Share on other sites
Constabulary Report post Posted May 31, 2014 can´t help but thats one reason why I like my old Singer 111 so much - it has a dial with SPI markings. Quote Share this post Link to post Share on other sites
BDAZ Report post Posted May 31, 2014 Take a pencil and mark on the outside of the adjustment slot when you get a stitch lenght you like. I tried that but it's not really accurate enough on my 3200. Cya! Bob Quote Share this post Link to post Share on other sites