Looking For A Special Tool (Stamp)

[kowoshisan]

hi my name is richard, i am from vienna/austria

i am new to leatherwork and to this forum. My first topic is about a stamp, i am looking for.

Do not now, if that is custom, or where i can buy it.

Try to describe it in my poor english.

looks like a beveler, that bevels both sides, like a V or also good a U in the leather. Perfect would also

be one that brings a U outside the leather.

Made a sketch for better understanding. and i post also a picture ( hope that is OK) from xian leather where you can see

how the tool works.

i am glade that i have found this place, where i can find so much know how and inspiration.

regards from vienna

richard

[Sylvia]

hi my name is richard, i am from vienna/austria

i am new to leatherwork and to this forum. My first topic is about a stamp, i am looking for.

Do not now, if that is custom, or where i can buy it.

Try to describe it in my poor english.

looks like a beveler, that bevels both sides, like a V or also good a U in the leather. Perfect would also

be one that brings a U outside the leather.

Made a sketch for better understanding. and i post also a picture ( hope that is OK) from xian leather where you can see

how the tool works.

i am glade that i have found this place, where i can find so much know how and inspiration.

regards from vienna

richard

Craftool B997 Double beveler is V-shaped.

[kowoshisan]

oh thank you, are there other options, on the picture it looks like it makes a very broad V. but i will order it thank you

[electrathon]

The edging is done with an edging tool. It has a screwdriver like handle and you pull it along the edge to make the line and smooth edge. The other lines look to me like you want to cut them in with a swivel knife. The double line (#4) is cut with a special blade.

Aaron

[kowoshisan]

and the lines with the small dots ( the atom design), i think they are cut with a swifle knife and than ??? i looks like a thin (round???) line in the leather.

r

[JLSleather]

It LOOKS like you're talkng about a gouge. Available in "V" or "U" shapes, for making tight folds.

http://www.tandyleatherfactory.com/en-usd/search/searchresults/31811-00.aspx

Edited February 26, 2012 by JLSleather

[WinterBear]

#4 looks like it might also be from a push beader, such as what Barry King has?

http://www.barrykingtools.com/handtools.htm

[electrathon]

I think 4 was done with this blade: http://www.tandyleatherfactory.com/en-usd/search/searchresults/8029-00.aspx

[kowoshisan]

thank you for the information, will check them all

r

[King's X]

The dots are probably done with a tool commonly referred to a "seeder."