ScrapMonkey
-
Content Count
5 -
Joined
-
Last visited
Everything posted by ScrapMonkey
-
What is the diameter and length of mighty wonder main rod
ScrapMonkey replied to ScrapMonkey's topic in How Do I Do That?
At this point I could just use a guesstimate what do you think it is by throwing a ruler against it -
Any one can tell me the diameter of the main column? If you have one, what is the length of that main rod minus the screw on top.
-
Purchased fall 2019 from Techsew. I am cutting material that is to soft for machine I couldn’t get it to cut correct( all mechanical parts non electronic with machine. ) . It is for vegtan leather greater than 5-6 ounce. Want to sell for $1,800 I will include the table and servo motor - willing to negotiate on those SEPARATE items. Local pick up only - Tulare county California 93274. It weighs 250pounds my name is Ken - only serious buyers will I give out my phone number to. Thanks
-
I own Juki 1508s . GOLDSTAR GSM550 will not let me go lower than 1600 RPM. I have speed reducer installed. This model uses a needle positioner that I like. Question- need a new motor that allows RPM 500- 3500 but also has needle positioner that fits Juki AMCO shaft. ( see picture of needle positioner) Or how do I tell the servo to go slower from computer module...Any opinions?
-
My JUKI came with a Goldstar GBSM 500 servo motor. I lost the instructions of what the buttons do. One is speed, one says allows you to switch between P1 and P2 ?? I thought that was part of the positioned mechanism but nothing changers when I use it, third but allows change from F1,F2,F3. I don’t know about this. help if you can