Jump to content

ScrapMonkey

Members
 View Profile  See their activity

  • Posts

    5

  • Joined

  • Last visited

 Content Type 

Everything posted by ScrapMonkey

  1. ScrapMonkey
    At this point I could just use a guesstimate what do you think it is by throwing a ruler against it
  2. ScrapMonkey
    Any one can tell me the diameter of the main column? If you have one, what is the length of that main rod minus the screw on top.
  3. ScrapMonkey
    Purchased fall 2019 from Techsew. I am cutting material that is to soft for machine I couldn’t get it to cut correct( all mechanical parts non electronic with machine. ) . It is for vegtan leather greater than 5-6 ounce. Want to sell for $1,800 I will include the table and servo motor - willing to negotiate on those SEPARATE items. Local pick up only - Tulare county California 93274. It weighs 250pounds my name is Ken - only serious buyers will I give out my phone number to. Thanks
  4. ScrapMonkey
    I own Juki 1508s . GOLDSTAR GSM550 will not let me go lower than 1600 RPM. I have speed reducer installed. This model uses a needle positioner that I like. Question- need a new motor that allows RPM 500- 3500 but also has needle positioner that fits Juki AMCO shaft. ( see picture of needle positioner) Or how do I tell the servo to go slower from computer module...Any opinions?
  5. ScrapMonkey
    My JUKI came with a Goldstar GBSM 500 servo motor. I lost the instructions of what the buttons do. One is speed, one says allows you to switch between P1 and P2 ?? I thought that was part of the positioned mechanism but nothing changers when I use it, third but allows change from F1,F2,F3. I don’t know about this. help if you can
×
×
  • Create New...