Members Jhunter13 Posted April 5, 2022 Members Report Posted April 5, 2022 (edited) Well...wasnt in the market for another machine, but some deals are too good to pass up. Paid $500. Less than two years old, still has the plastic on the decals and not a sign of wear. Is putting down decent sticthes but plan on going through it anyway to get it dialed in and make sure everything is timed. Came with a servo motor, but I plan on upgrading to a brushless and adding a needle positioner at some point. Picture of servo Edited April 5, 2022 by Jhunter13 Quote
Members ChipperBags Posted October 11, 2022 Members Report Posted October 11, 2022 Nice machine! Quote
Members Gump Posted October 21, 2022 Members Report Posted October 21, 2022 I just yesterday put a Sewquiet 6000 on a Consew 206RB3. The adapter for the syncro won't mount on my pulley, it has a three hole pattern and the center mount screw is a different size. I had to make an adapter plate to make it work. Machining was required, but not hard. I used a piece of UHMWPE (plastic) that turns easy, could be done on a wood lathe. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.