sbrownn Report post Posted October 3, 2022 Has anyone done any printing with PETG filament? Quote Share this post Link to post Share on other sites
Chakotay Report post Posted October 3, 2022 I have. . . . and decided I much prefer just printing PLA. Quote Share this post Link to post Share on other sites
K5HEP Report post Posted July 18, 2023 (edited) I know that this is an older thread, but I do have an answer to your question. I started out using PLA, but soon switched to PETG. Alot of my 3D prints are used in an outdoor environment and PLA just did not stand up to the task, so I switched to PETG and have not look back. I run a nozzle temp of 230 deg C and a bed temp of 90 deg C. I also use a PEI magnetic build plate to aid in removing my 3D prints from the bed - PETG really sticks to your build plate the PEI really helps in removing your prints... Edited July 18, 2023 by K5HEP Quote Share this post Link to post Share on other sites
