RKCrowe Report post Posted June 29, 2023 Good day, I am seeking advice. I made a belt for work. The edge coat (fiebings) rubs off on to my shirt, white shirt of course, when it gets wet from rain or sweating. Is there a way to prevent this from happening or do I need to refinish the edges with a different method or material? Thank you Richard Quote Share this post Link to post Share on other sites
SUP Report post Posted June 29, 2023 You could try applying Resolene over the edge coat. Dilute it with water because it can leave a white residue if it is too thick in any place. Two thin layers, with drying in between, would work. Resolene works better for preventing dye running than anything else for me. Quote Share this post Link to post Share on other sites
RKCrowe Report post Posted June 29, 2023 Thanks for the quick response. I’ll give it a try. Quote Share this post Link to post Share on other sites
SUP Report post Posted June 29, 2023 I apply it with one of those pens with sponge at the tip that I fill with a diluted solution of Resolene. It allows a thin coat. Quote Share this post Link to post Share on other sites
RKCrowe Report post Posted June 29, 2023 How diluted? Quote Share this post Link to post Share on other sites
Danne Report post Posted June 29, 2023 (edited) Fiebings edge kote? if that's the case, I would recommend you to use another product, that product is garbage (For those who don't agree show me a clean nice result, and also a durable edge with that edge paint) A couple of alternatives (In no particular order) Uniters, Fenice, Giardini, Stahl, Vernis600, If you make a lot of belts, then it's a lot of surfaces to paint so Giardini with their primer is probably a good choice, you can get a decent result with two coats (one coat of primer and one coat of edge paint) Edited June 29, 2023 by Danne Quote Share this post Link to post Share on other sites
SUP Report post Posted June 29, 2023 I just eyeball it - about 50%. And for dye, I use ordinary Fiebings Pro dye. I have no idea about edge kote. Quote Share this post Link to post Share on other sites
TomE Report post Posted June 29, 2023 A traditional saddler's edge dye is a mixture of dye and pearl glue/hide glue. Dye and burnish the edge in one step. Some folks use dye plus PVA glue (white Elmers glue). I think there are discussions about this on this forum. I use Pro Dye mixed 50:50 with Martins Edge Solution which does a good job slicking the edge of bridle leather. Another approach is to apply beeswax to the edge with a heated edge iron. The wax penetrates the leather. Need to buff thoroughly to remove excess wax. Quote Share this post Link to post Share on other sites
RKCrowe Report post Posted June 30, 2023 I have never been disappointed on this site. Thanks to everyone who has responded. Quote Share this post Link to post Share on other sites
