327fed Report post Posted October 24, 2023 I have a well worn and cantankerous Consew 225 with a clutch motor and homemade speed reducer. My friend has a pristine Juki LU 562 with reverse. Looks like it just came from the factory. Would the Juki be a direct swap to my table and motor/reducer setup as they are both Singer clones? I would consider buying his if the table would fit both, but the stuff in my leather shop would make a table swap close to impossible. Quote Share this post Link to post Share on other sites
fibersport Report post Posted October 24, 2023 I'm not familiar with the Juki line but my Pfaf fit right into the opening that had my Singer, I do believe the openings are pretty standard although you might have to tweak things a little. Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted October 24, 2023 12 hours ago, 327fed said: Would the Juki be a direct swap to my table and motor/reducer setup as they are both Singer clones? Yep. At one point in time, I had two Singer (96k40 and 31-20), one Juki 563 and a Pfaff 138 all fitting onto the same table. I had to move the knee lever around to use the different heads Quote Share this post Link to post Share on other sites
