rfkoen Report post Posted October 30 The limiting pin on my Tandy pro press recently broke. Do any of you know what size pin is needed to replace it? Thanks in advance for your help! Quote Share this post Link to post Share on other sites
fredk Report post Posted October 31 2 hours ago, rfkoen said: The limiting pin on my Tandy pro press I have a Tandy Pro-Press and it doesn't have any such 'limiting pin' Quote Share this post Link to post Share on other sites
Arturomex Report post Posted November 2 (edited) On 10/30/2024 at 3:36 PM, rfkoen said: The limiting pin on my Tandy pro press recently broke. Do any of you know what size pin is needed to replace it? Thanks in advance for your help! Are you referring to the limiting pin that mounts in the handle? Referred to as the "stop pin" in the instruction manual? https://cdn.shopify.com/s/files/1/0063/5997/3970/files/PKG-21-003_TandyPro_Hand_Press_-_Instructions_NO_CROPS.pdf?v=1631115666 Edited November 2 by Arturomex Quote Share this post Link to post Share on other sites
fredk Report post Posted November 2 Mea culpa Caveat; my press is an earlier version in grey The pin is shanked on both sides. It is approx 5.8 mm (15/64 inch ?) on the outside (both sides) and is straight cut narrowed from approx 6.5 mm (1/4 inch ?) which goes thru the handle. It is approx 30.85 mm (1 7/32 inches ?) long, but has room to be a slightly longer Quote Share this post Link to post Share on other sites
