Singer 211 U166A walking foot problem

[NowhereMan01]

I have a Singer 211U166A that I got for free, including table, servo motor, bobbins, and needles. I'm completely new to sewing, and the machine was not working when I got it. Fortunately, a local repair guy got it going, and I was able to sew several things with it--not leather, but some very thick, heavy, multiple layers of cloth (mostly, sailing-related).

Yesterday, the bobbin got jammed, and my foot slipped, no doubt putting a lot of pressure on the drive, which resulted in a clunking noise, and a screw that connects to the reverse lever even fell off. I was able to replace the screw, but now the walking foot seems to not be walking. Specifically, the middle part of the walking foot stays pressed down on the fabric the entire cycle, and hence the cloth does not feed. I have posted a short video here:

 

 

Any suggestions would be greatly appreciated!

[friquant]

Can the middle walking foot be raised by hand (with motor unplugged)?

Looks like the feed dog timing is also off. (Normally needle would be at bottom dead center, and the feed dog at maximum height, when the feed dog is halfway through its front to back stroke.)

Do you have a manual?

[NowhereMan01]

2 hours ago, friquant said:

Can the middle walking foot be raised by hand (with motor unplugged)?

Looks like the feed dog timing is also off. (Normally needle would be at bottom dead center, and the feed dog at maximum height, when the feed dog is halfway through its front to back stroke.)

Do you have a manual?

Thanks for the quick response.

I'm not sure what you mean by raising the middle foot "by hand", but everything seems very rigid, unless I turn the wheel. 

Yes, I do have the manual, which can be found here:

https://s3.amazonaws.com/a.teamworksales.com/SINGER+SERVICE+MANUALS/211U157A_165A_166A_566A.pdf

The only thing I've found in it that looks at all relevant is on p. 25, "ADJUSTMENT OF THE LIFTING ECCENTRIC AND THE LIFT OF THE ALTERNATING PRESSER FEET". If there is anything else in it that I should be looking at, LMK.

 

[friquant]

 

10 hours ago, NowhereMan01 said:

I'm not sure what you mean by raising the middle foot "by hand", but everything seems very rigid, unless I turn the wheel. 

that's good! Just wanted to check that the middle foot had not been disconnected from the driving apparati.

 

10 hours ago, NowhereMan01 said:

If there is anything else in it that I should be looking at, LMK.

Here's what I would check, in this order.

 

1. Page 13, "Reengage safety clutch". It's typical when the bobbin binds up for the safety clutch to trip. Make sure it's reengaged.
2. Page 13 "Reverse Feed Mechanism". You mentioned a screw came off. I would inspect the reverse feed to make sure all the parts are in place and moving properly.
3. Page 26, "Replacement of Arm Shaft Connection Belt". You don't need to remove the belt, but follow the instructions for verifying that the arm shaft (the one that the hand wheel bolts to) is in time with the hook shaft.
4. Page 24, "Feed Eccentric Adjustment". You need to get the feed dog so that it halfway through it's fore-aft stroke when the needle is at bottom dead center.
5. Page 23 and 24, "Feed Dog Adjustment". You want the feed dog to be at its highest point when the needle is at bottom dead center
6. Page 25, "Lifting Eccentric and Alternating Presser Feet".