PFAFF 346-H2 DOUBLE NEEDLE CYLINDER ARM MACHINE

[GPD]

Time to move my 346 along to a new caretaker.  I picked up this cylinder arm machine about three years ago and have had it in dry storage since.  While recommissioning it recently, I found that it does not reliably pick up the bobbin thread.  This adjustment is beyond my skill set.  Buyer gets the machine, table and clutch motor.  A table/insert to provide a flat surface, a 3-ring binder with useful info such as manuals and parts list.  Pickup on west central Connecticut.  $400.00.

EDIT:

I put some time into inspecting and rectifying the machine and now have the left hand needle position sewing. 

 

test reply by gary

Edited September 8, 2025 by Northmount
Updated info at OP's request, left needle now stitching

[esheeran]

On 9/2/2025 at 9:46 AM, GPD said:

Time to move my 346 along to a new caretaker.  I picked up this cylinder arm machine about three years ago and have had it in dry storage since.  While recommissioning it recently, I found that it does not reliably pick up the bobbin thread.  This adjustment is beyond my skill set.  Buyer gets the machine, table and clutch motor.  A table/insert to provide a flat surface, a 3-ring binder with useful info such as manuals and parts list.  Pickup on west central Connecticut.  $400.00.

test reply by gary

Hi GPD, how much does it weigh? Can the machine be removed from the table?  What are the measurements for the whole thing? What thread will it take and what thickness will it sew (when it’s working) do you know? Can I come and take a look at it?

Edited September 4, 2025 by esheeran
More questions

[GPD]

Esheeran;

I sent a message to you yesterday.  check your in basket.

 

 

[Northmount]

12 hours ago, GPD said:

Esheeran;

I sent a message to you yesterday.  check your in basket.

 

 

Helps if you quote a part of the post or tag the user so they get a notification in case they don't have notifications setup correctly.

@esheeran

On 9/4/2025 at 6:27 AM, esheeran said:

Hi GPD, how much does it weigh? Can the machine be removed from the table?  What are the measurements for the whole thing? What thread will it take and what thickness will it sew (when it’s working) do you know? Can I come and take a look at it?