Pfaff motor 2545

[Moti]

Someone can help me 

I just got this motor it was on pfaff 2545 the guy didn’t want it

So he give me motor  accelerator pedal and the driver, but it didn't have the controller and I can't find it anywhere. Where can I find one? The motor works for a few seconds and then doesn't continue to work at all. Every time i turn it on, the same thing happens. And there was no needle positioner on this machine. Maybe it's something internal, I don't know.

Edited 13 hours ago by Moti

[friquant]

3 hours ago, Moti said:

So he give me motor  accelerator pedal and the driver

Can we get a photo of the back of the box that says "pico drive"?

Also can we get separate photos of each piece that plugs into the back of the motor?

I'm not familiar with this model, but trying to see if all the parts are here.

[dikman]

I found this for you (didn't take long) it may be of some help. You could try asking Pfaff about a controller but I suspect the cost would be high - if they have one. The chances of getting one used would probably be low. Pity, it looks like a nice motor. Good luck.

picodrive_p40pd.pdf

[Moti]

1 hour ago, dikman said:

I found this for you (didn't take long) it may be of some help. You could try asking Pfaff about a controller but I suspect the cost would be high - if they have one. The chances of getting one used would probably be low. Pity, it looks like a nice motor. Good luck.

picodrive_p40pd.pdf 1.12 MB · 1 download

Thank you 

this is very helpful I try to find this to and didn’t find anything 

 

[Moti]

2 hours ago, friquant said:

Can we get a photo of the back of the box that says "pico drive"?

Also can we get separate photos of each piece that plugs into the back of the motor?

I'm not familiar with this model, but trying to see if all the parts are here.

So I have only 3 pieces of it, motor driver and eccelerator, looking for the controller 

[friquant]

This box looks complex. It has the following ports which are common to a lot of digital servo motors:

X1, X2: motor

X3: gas pedal

X7: needle positioner

But then there's additionally X5 (head unit) and X4 (looks like a control panel) that most digital servo motor's don't have. In other words, I'll bet this is a proprietary system and that it will be difficult to buy the pieces individually.