Members dfd Posted March 13, 2012 Members Report Posted March 13, 2012 I've been making a few holsters and it's been going good but someone pointed out that I need to do something so that the rivets and snaps used in construction don't come in contact with the gun.Is there some way that you holster folks address this problem? Quote
mlapaglia Posted March 13, 2012 Report Posted March 13, 2012 You can sandwich the rivet or snap bottom between two pieces of leather. I am doing a IWB holster and the T-nuts are between the two layers of leather I used for the front. Two pieces of 4/5 oz glued together with the grain out on both sides. This is my top piece and I put the T-nut between the two layers. I have also recessed a rivet then glued a circle of leather about the size of a quarter over the rivet bottom. It stays in place and protects the surfaces. But that is not as good as putting the bottom between two pieces of leather. Michael Quote
Members mrdabeetle Posted March 13, 2012 Members Report Posted March 13, 2012 You can countersink the rivet using a french edge skiver. Here's a link to a video showing how it is done. http://bcove.me/iz6ocvvs Quote
Members Dwight Posted March 13, 2012 Members Report Posted March 13, 2012 If you will show us a drawing or picture of your dilemma, . . . it will be easier to address that way. May God bless, Dwight Quote
Members camano ridge Posted March 13, 2012 Members Report Posted March 13, 2012 For the ones you have already made take a look at High Desert Leather http://www.highdesertleather.com/id74.html. they sell plastic snap back covers for line 24 snaps that will help protect your weapons. Scott Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.