Cowboy Fast Draw Association Rig Build

[DHopper]

Have to agree; looks really good to me!

[IngleGunLeather]

That sure looks good to me, great job!

Josh

Thanks Josh! I appreciate the advice you gave me on marking borders and stamping. I tried to apply those techniques as best as possible. I used a groover instead of a swivel knife though. I'll have to experiment on some scraps with the swivel knife after I finish this. Again, thanks for the compliments and tips.

CT

Edited November 16, 2012 by CountryTrash

[IngleGunLeather]

Have to agree; looks really good to me!

Thanks Dave.

[IngleGunLeather]

Late Day Six. I got started on the loop strap this evening and couldn't stop after that. I decided to go ahead and get both the holster and loop strap wet molded. I'll be able to let in dry over the next 8-10 hours and then got back over the edges with the canvas again. So, still a little bit aways from being completely finished. Such as installing the leg tie downs, hammer strap, oiling, and finish coat. I figure that by Sunday the finish coat can be applied. Oh, if you're wondering why the toe of the flap is bent up like that is it's because I have a deflector shield installed inside the flap. The purpose of that is that in the event of an accidental or early discharge, the wax bullet will deflect off the shield vise smacking you in the leg.

Edited November 17, 2012 by CountryTrash

[IngleGunLeather]

Day Seven. Okay folks. Here's the finished holster. The last few things that were taken care of today was adding the hammer strap, leg tie-downs, and a couple coats of natural finishing wax. Stay tuned for part 2 where I'll be working on the belt. Thanks for all the motivating comments so far. You guys and gals rock!

[DHopper]

Great looking work, CT. Well done!

Dang phone. LoL.

Edited November 18, 2012 by DHopper

[IngleGunLeather]

Great looking work, TC. Well done!

Thanks HopperD.

[MadMorbius]

Top notch job!

[SooperJake]

Very Nice!

.

[Tac]

Wow! Can't wait to see it on a belt! Great job!

-Tac