Members Cascabel Posted April 12, 2014 Members Report Posted April 12, 2014 When selecting reverse on my new CB4500, the lever will not stay put. It falls back down on it's own if I do not hold it up. Sometimes when I do repair work, I need to support the work with one hand, and guide it with the other, with no way to hold the lever up for the couple of stitches needed to lock the stitching. Is there a way to add a bit of friction to the lever so that it stays up until I want it back down in the forward stitching position ? Quote
CowboyBob Posted April 12, 2014 Report Posted April 12, 2014 You have to take off the back cover plate & tighten the screw in this pic just alittle. Quote
Members Cascabel Posted April 12, 2014 Author Members Report Posted April 12, 2014 On 4/12/2014 at 2:40 PM, CowboyBob said: You have to take off the back cover plate & tighten the screw in this pic just alittle. Thanks, Bob, that snugged it up nicely !! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.