Cascabel Report post Posted April 12, 2014 When selecting reverse on my new CB4500, the lever will not stay put. It falls back down on it's own if I do not hold it up. Sometimes when I do repair work, I need to support the work with one hand, and guide it with the other, with no way to hold the lever up for the couple of stitches needed to lock the stitching. Is there a way to add a bit of friction to the lever so that it stays up until I want it back down in the forward stitching position ? Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted April 12, 2014 You have to take off the back cover plate & tighten the screw in this pic just alittle. Quote Share this post Link to post Share on other sites
Cascabel Report post Posted April 12, 2014 You have to take off the back cover plate & tighten the screw in this pic just alittle. Thanks, Bob, that snugged it up nicely !! Quote Share this post Link to post Share on other sites
