Basically Bob Report post Posted July 3, 2014 Thought you might like to take a look at these two molded cases. Quote Share this post Link to post Share on other sites
HippieLee Report post Posted July 3, 2014 Those are nice but please tell me more about your anti-gravity table! Quote Share this post Link to post Share on other sites
Basically Bob Report post Posted July 3, 2014 Dang ... I have no idea why the photos I post on this site or not oriented properly. Nor do I know how to fix it! Quote Share this post Link to post Share on other sites
Hi Im Joe Report post Posted July 3, 2014 Really clean nice work! Quote Share this post Link to post Share on other sites
HippieLee Report post Posted July 3, 2014 lol, it's ok - even upside down those are some really nice sheaths. I have a gerber multi-tool I need to make a case for so I really do appreciate you sharing yours with us. Quote Share this post Link to post Share on other sites
Basically Bob Report post Posted July 3, 2014 Stitched at 7 spi and used a Dixon 1 1/2" pricking iron. I finally have the corners nailed and actually prefer to use the 1 1/2" iron rather than the 1/2" or two tooth iron I have. Finished with 7 spi overstitch wheel. Quote Share this post Link to post Share on other sites
LoyalNine Report post Posted July 4, 2014 Very nice. What weight is the leather you used? Curious what you did for a belt loop. Well Done! Quote Share this post Link to post Share on other sites
Basically Bob Report post Posted July 4, 2014 LoyalNine, thanks! The leather is a little on the heavier side - 7 oz. i used it because I had a piece that was a little stiffer than norm and I thought it would suit this application well. I out the belt loop together using Al Stohlman's, case making, volume one as a guide and use his standards for everything I do, concerning hardware attachment and loops etc. Here's a pic - a little rough but it 'll get the job done! Quote Share this post Link to post Share on other sites
