thefanninator Report post Posted August 21, 2014 (edited) 4.5 oz Horween Orion leather. Stitched inside out and then turned right side out. I used Irish linen thread from Royalwood Ltd. and a Vergez Blanchard pricking iron @ 9 spi. Too bad the stitching is on the inside. I like to see it usually. Tandy Pro Edge paint on the handles and top edge of the tote. If you haven't tried it it's actually made by Fenice from Italy, the stuff rocks! Inside the handles is just some cotton piping cord from Joann's. I'd like to find some stiffer wool felt cord. I'm pretty happy with it and ready make the next one better. Approximately 12 x 8 inches. Edited August 21, 2014 by thefanninator Quote Share this post Link to post Share on other sites
rawr66 Report post Posted August 21, 2014 Looks good! I like the colour. Quote Share this post Link to post Share on other sites
MonicaJacobson Report post Posted August 22, 2014 Very nice! Between yours and Claire's, I see I need to sew my handles much further down on the next one. Quote Share this post Link to post Share on other sites
Wild Bill46 Report post Posted August 24, 2014 I really like the simplicity ! Quote Share this post Link to post Share on other sites
thefanninator Report post Posted October 4, 2014 This one has been sitting around awhile and I finally finished it. I like the way the handles are sewn on much better. Quote Share this post Link to post Share on other sites
MonicaJacobson Report post Posted October 4, 2014 Nice! This one, if possible, is a 50% improvement over your first one. It looks great! Quote Share this post Link to post Share on other sites
Wild Bill46 Report post Posted October 4, 2014 I still enjoy the simplicity of these two bags. A question if you don't mind ? In stitching these handles on, did you sew them on before you reversed it inside out ? or the other way around ? Not that it matter at all, I just wondered while looking at its simplicity. --------------- Wild Bill46 Quote Share this post Link to post Share on other sites
thefanninator Report post Posted October 4, 2014 (edited) These two were made before I knew to put the handles on first. The bodies were made of two pieces, stitched together then turned right side out then the handles were stitched on. Don't do it that way. This one was made of one piece for the body. The handles were stitched on first, then stitch the body and flip right side out. http://leatherworker.net/forum/index.php?showtopic=58466 Edited October 4, 2014 by thefanninator Quote Share this post Link to post Share on other sites
