Jump to content

Recommended Posts

  • Members
Posted

Love to hear that Charlie!

Thank you

Scott

Thanks for the burnisher Slipangle. It is perfect, just what I was hoping it would be.

Charlie


Will do, C-dog

thank you

Scott

PM me when you get them for the dremmel tool

  • 2 weeks later...
  • Members
Posted

Please let me know when you finish the ones for the Dremel.

  • Members
Posted

I'll try, Jumpout,

and thanks. But I have to be honest. It may be a while.

Circumstances of life may not allow for it for a while.

But we'll see, Thanks

Scott

Please let me know when you finish the ones for the Dremel.

  • 5 months later...
  • Members
Posted

Hi, I would love to buy one of these from you. Please let me know if you have anymore or if you can make me one.

What size is the shank?

Thank You,

JGB

  • Members
Posted

#2 SOLD. Pending payment. Thanks. I'm going to do up some small burnishers for Dremel tools too. Stay tuned.

I look forward to this! I'd love one with similar grooves and a hole burnishing tip.

  • Members
Posted

Hi JGB,

Sorry for the late reply. I just got in last night from 8 days in Belize.

Thank you for the note, and interest. However, I doubt I'll be making any more burnishers out of this wood. I may, but it is doubtful. The reason is I used the last small blank of it to make two awl hafts. I did find one more small piece of the wood in my wood stash but I probably won't make burnishers out of it. It is just too rare these days and I think other woods will work as well, or better, as burnishers. For now, I'm concentrating on awl hafts though. If I come up with something else though, I'll keep you posted. Thanks again. By the way, the shank on those two I made was 1/4 inch.

Thanks,

Scott

Hi, I would love to buy one of these from you. Please let me know if you have anymore or if you can make me one.

What size is the shank?

Thank You,

JGB

  • Members
Posted

Hello,

Sorry for the tardy reply. I just got back in last night from 8 days in Belize.

Thanks for the note, and interest. I may yet try some very small burnishers out of lignum vitae but, to tell the truth, I may try it with other woods. The main problem I've found with this wood is attaching the shank to the wood. I haven't tried it yet with this wood, and 1/8 shanks, but gluing this wood is nearly impossible, given its extremely high oil content. I may try some experimenting soon, to see if I can get a good, tight press fit, and avoid the burnisher spinning on the shank. But for now, I'm still concentrating on awl hafts. If I come up with something that works well enough to sell them , though, I'll let you know.

Thanks,

Scott

I look forward to this! I'd love one with similar grooves and a hole burnishing tip.

  • Members
Posted

Ok. Thanks for letting me know. If you do come up with one out of another wood, especially with an 1/8" shank, I would love to buy one.

Thanks,

JGB

Guest
This topic is now closed to further replies.
×
×
  • Create New...