Members Colt Hammerless Posted December 13, 2014 Members Report Posted December 13, 2014 Just wondering if anyone has a holster plate for a 441 clone they aren't using, and would like to sell. Mine is a Toro 3000, but I think a plate from any of the clones will work. Paul
Members Colt Hammerless Posted December 13, 2014 Author Members Report Posted December 13, 2014 I just put an ad in the "Want to Buy" sub-forum for a used holster plate for a Toro 3000. I think I read somewhere on here that a plate from any of the 441 clones will work, but wanted to confirm that. Has anyone here mixed and matched needle plates between brands? Paul
Contributing Member JLSleather Posted December 15, 2014 Contributing Member Report Posted December 15, 2014 The holster plate off the cobra 4 looks to have a hole spacing (measured in a straight line) of about 38 mm (center lines). This close on the artisan? "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Members Colt Hammerless Posted December 16, 2014 Author Members Report Posted December 16, 2014 Hmmmm......That second post down was supposed to go in the sewing machine sub-forum. Don't know why it ended up here. JLSleather, I just measured mine at 1.57 inch, which converts to 39.9 millimeters. Thank you very much for the measurement. I'll try to re-post my question in the sewing machine forum. Paul
Recommended Posts