Colt Hammerless Report post Posted December 13, 2014 Just wondering if anyone has a holster plate for a 441 clone they aren't using, and would like to sell. Mine is a Toro 3000, but I think a plate from any of the clones will work. Paul Share this post Link to post Share on other sites
Colt Hammerless Report post Posted December 13, 2014 I just put an ad in the "Want to Buy" sub-forum for a used holster plate for a Toro 3000. I think I read somewhere on here that a plate from any of the 441 clones will work, but wanted to confirm that. Has anyone here mixed and matched needle plates between brands? Paul Share this post Link to post Share on other sites
JLSleather Report post Posted December 15, 2014 The holster plate off the cobra 4 looks to have a hole spacing (measured in a straight line) of about 38 mm (center lines). This close on the artisan? Share this post Link to post Share on other sites
Colt Hammerless Report post Posted December 16, 2014 Hmmmm......That second post down was supposed to go in the sewing machine sub-forum. Don't know why it ended up here. JLSleather, I just measured mine at 1.57 inch, which converts to 39.9 millimeters. Thank you very much for the measurement. I'll try to re-post my question in the sewing machine forum. Paul Share this post Link to post Share on other sites
