cgleathercraft Report post Posted February 3, 2015 Metal Corner protectors WAY too many to count. $0.05 per piece + shipping Depending on how many ordered I may cover shipping and give discount. Share this post Link to post Share on other sites
Troy Burch Report post Posted February 3, 2015 (edited) How big are these? lol, never mind It helps when I read the header. Edited February 3, 2015 by Troy Burch Share this post Link to post Share on other sites
cgleathercraft Report post Posted February 3, 2015 No worries! Been there, done that myself Share this post Link to post Share on other sites
rlpullman Report post Posted February 3, 2015 What is the maximum thickness theses can be used on? Share this post Link to post Share on other sites
cgleathercraft Report post Posted February 3, 2015 I will get the measurement tonight. Share this post Link to post Share on other sites
cgleathercraft Report post Posted February 4, 2015 I wouldn't go more than 10 oz. They fit very cleanly on the 6 and 8 oz pieces I tried. 12 oz (two 6 oz pieces back to back) was too thick. Share this post Link to post Share on other sites
Troy Burch Report post Posted February 4, 2015 Are you in the USA? Share this post Link to post Share on other sites
capsterdog Report post Posted February 4, 2015 Are they easy to bend over? Share this post Link to post Share on other sites
cgleathercraft Report post Posted February 4, 2015 Are you in the USA? Yes Northern Missouri, about 1.5 hours north of KC Are they easy to bend over? I used a small tack hammer that I picked up at Menards. Light taps had them holding strong enough that it took pliers to get them off. I believe a small arbor press would work better to crimp them a little tighter but I don't have one to test with. Share this post Link to post Share on other sites
capsterdog Report post Posted February 4, 2015 thank you Share this post Link to post Share on other sites
cgleathercraft Report post Posted April 8, 2015 I have about 3000 of these left. Every reasonable offer considered. Share this post Link to post Share on other sites
stelmackr Report post Posted April 9, 2015 PM sent Bob Stelmack Share this post Link to post Share on other sites
cgleathercraft Report post Posted April 9, 2015 Sold, Pending Payment. Share this post Link to post Share on other sites
cgleathercraft Report post Posted April 9, 2015 Sold, Thank you everyone! Share this post Link to post Share on other sites
