rlpullman Report post Posted March 1, 2015 I have seen several sites where they have holsters that have a type of retention adjusting screw. They look kind of like a Chicago screw with a rubber grommet. They are used to adjust the amount of retention on the hand gun. Does anyone here know of a supplier where I can get these? Quote Share this post Link to post Share on other sites
TwinOaks Report post Posted March 1, 2015 Local hardware store- You'll need a t-nut, a bolt, a finish washer (aka 'cup washer'), and about 1/2" of rubber hose from the plumbing section. Quote Share this post Link to post Share on other sites
camano ridge Report post Posted March 1, 2015 (edited) Like Twin oaks said you can get pretty much everything you need at a hardware store or one of the big box stores. Below is a picture that shows pretty much every thing you need. If you don't want to collect everything you need you can get what you need from Rob Bennett the bluegunstore.com. Index fastners http://www.ifithermoplastics.com/category/fasteners also has everything you need. Edited March 1, 2015 by camano ridge Quote Share this post Link to post Share on other sites
rlpullman Report post Posted March 1, 2015 Thanks you guys. That's too easy Quote Share this post Link to post Share on other sites
cgleathercraft Report post Posted March 2, 2015 I ordered all my hardware from here: . Index fastners http://www.ifithermoplastics.com/category/fasteners hasn't shown up yet, and I don't use hardware for retention but they had everything I wanted/needed and were way cheaper than the hardware store. Quote Share this post Link to post Share on other sites
