Help I Think I Stripped A Gear Or Something?

[Carrieanna1172]

Here is a video of the point I am at now?.

Some direction would be greatly appreciated

[Carrieanna1172]

Ps there was a loose set screw when I get under there

[Northmount]

While you have the gears "out of mesh", can you turn the bobbin basket/hook? I not, there is something jamming the the basket/hook from turning. Something like a broken part of a needle, or threads jammed up tight underneath.

Clear that problem up, then you can go about setting the gears in the right position and proceed with setting the timing. Any time you have a machine jam, look for something in the bobbin basket/hook area first and make sure that is clear. And put a new needle in.

Tom

[pcox]

sent you a PM

[Carrieanna1172]

North mount

When the gears are out of sync or not touching it spins

Well it was spinning and now no

The basket the bobbin goes in won't move at all

Edited March 8, 2015 by Carrieanna1172

[Carrieanna1172]

Ok update I think I got the timing set right !!,!

The manual tejas sent was extremely helpful! A thousand thanks to all of you

Such a great group on here to just jump in and help out!

I think it needs a tiny bit of tweaking the stitches are small? And I think my walking feed is loose

Maybe a new set of screws

I broke one off and had to drill it out

Anyway thanks again to you all

[piera]

Im having the same issues above.. I just got a Consew 227r on friday! And my nylon bonded shredded and I cant seem to get safety clutch released.

I am so annoyed.