alfher Report post Posted October 14, 2015 (edited) Here again, looks like the previous one is not working.... Id Wallet.pdf Edited October 14, 2015 by alfher Quote Share this post Link to post Share on other sites
alfher Report post Posted October 14, 2015 You are welcome Neatpete Quote Share this post Link to post Share on other sites
SamB Report post Posted October 14, 2015 (edited) The last link is ok! Thank you for this pattern!!!! Edited October 14, 2015 by SamB Quote Share this post Link to post Share on other sites
alfher Report post Posted October 16, 2015 You are welcome SamB... Quote Share this post Link to post Share on other sites
whosurdaddy Report post Posted October 17, 2015 maybe stupid question: when you insert the cards into the 3 slots, whats to keep them from falling all the way to the bottom? thanks! Quote Share this post Link to post Share on other sites
alfher Report post Posted October 19, 2015 Sorry the delay, What I do is to cement a piece of fabric for each slot cut, like an envelope to hold the card, I don't know if is the best way, I just saw that on a tandy leather kit and though was a good idea. I cement one side right below the slot cut then I fold it and i glue the other side on top of the same slot cut and, I do the same on each one. Quote Share this post Link to post Share on other sites
