MudBugWill Report post Posted October 16, 2015 (edited) I am selling one of my card slot dies for bifold wallets. The dimenstions of the slot are 4.25" wide and 2.125" deep. This makes a card slot with T-construction. The top of the T hangs off either side when i assemble the wallet and is trimmed flush for a nice edge requiring minimum sanding. I have gone a different direction with my wallets and no longer need this die. It is still very sharp and is small enough to be used with a mallet most likely. $55 shipped Edited October 16, 2015 by MudBugWill Share this post Link to post Share on other sites
Boriqua Report post Posted November 12, 2015 Its an old post but ... is this still available? Share this post Link to post Share on other sites
