longtooth Report post Posted December 29, 2015 Got bored doing horse blankets and decided since it was Christmas, I would make a new holster for my CZ PO7. Interesting material to work with. Won't edge, difficult to mark a stitch line and when you sew it you have to increase the size of the needle so the thread won't fray. Comments always welcome. Thank you. Quote Share this post Link to post Share on other sites
Jarhead44706 Report post Posted December 29, 2015 Looks Good. Was Curious How This Material Is To Work With Quote Share this post Link to post Share on other sites
longtooth Report post Posted December 29, 2015 Forget to mention that the finishing touches was done with a Dremel tool. Quote Share this post Link to post Share on other sites
Jarhead44706 Report post Posted December 30, 2015 Good Info.Thanks For Sharing. Now I Need To Get Started On One Quote Share this post Link to post Share on other sites
chiefjason Report post Posted December 30, 2015 My CZ75b holster has a stingray panel inlaid under a leather panel so I didn't have to edge it or stitch it. Just glued it down. Would not work so well in your application. I can only imagine how tough that was to pull off. Quote Share this post Link to post Share on other sites
longtooth Report post Posted January 4, 2016 Chiefjason, The only difficult part of making the holster was cutting the stingray. Once I glued it to the leather and finished it with the dremel tool. the rest was a piece of cake. I worn it now for about a week and it holds it's body better than some older holsters that have a lot more wear on them. A year from now I think this holster will have the same body and tension. Quote Share this post Link to post Share on other sites
chiefjason Report post Posted January 6, 2016 FWIW, my Cutco toothed shears made pretty short work of cutting mine. Best thing I found. EMT style shears might work too. The teeth helped it hold onto the stingray instead of slipping on the spines. Quote Share this post Link to post Share on other sites
