OneCrow Report post Posted July 21, 2016 Hello All, Small Leather Project Bullet Holder commission. Uses Money clip to clip onto a shirt. Sorry for the cruddy pictures. Any critique or advice is welcome. Thank you. Quote Share this post Link to post Share on other sites
OneCrow Report post Posted July 21, 2016 Also made a version with a badge holder. Badge holder is baked leather to stiffen. Again, any critique or advice is welcome. Quote Share this post Link to post Share on other sites
Matt S Report post Posted July 21, 2016 Neat work. What's it for use with, a derringer? Quote Share this post Link to post Share on other sites
OneCrow Report post Posted July 21, 2016 Thank you. The cartridge caliber is 38. I'm not a gun expert by a long shot, but I believe that is mostly used as a small revolver hand gun round. I used 'Snap Caps' as stand in's for the cartridges. They worked pretty well. Though I found the snap caps to be ever so slightly smaller in diameter than the actual cartridges. Quote Share this post Link to post Share on other sites
Albob Report post Posted July 24, 2016 On 7/21/2016 at 0:09 PM, OneCrow said: Thank you. The cartridge caliber is 38. I'm not a gun expert by a long shot, but I believe that is mostly used as a small revolver hand gun round. I used 'Snap Caps' as stand in's for the cartridges. They worked pretty well. Though I found the snap caps to be ever so slightly smaller in diameter than the actual cartridges. Nice work on the clip idea. As a "gun guy" I think you'll find the slightly smaller snap caps will work perfect, you want the real bullets to fit tight, so as the leather ages, it should be about perfect. Quote Share this post Link to post Share on other sites
