Muddy Waters Report post Posted August 18, 2016 I need a pattern for a S&Wednesday 44mag model 629. Thanks!!! Quote Share this post Link to post Share on other sites
FNG Report post Posted October 27, 2016 Same here. I have the 5 inch barrel. This is all I can find I'm not sure it will fit the gun. The picture shows the more legacy revolvers where the grip had a much higher bore axis than the 629. The difference in bore axis dramatically changes fitment, I would think.http://www.zackwhite.com/Callahan-Shoulder-Holster-Pattern-Pack--P600080_p_6155.html Quote Share this post Link to post Share on other sites
CaptQuirk Report post Posted October 27, 2016 Get the Stohlman book on holsters, it has a very simple shoulder harness, and I believe a pattern for that pistol. I can double check later. Here's a link to the ones I made- http://smokewagonleather.us/shoulder.html Quote Share this post Link to post Share on other sites
JLSleather Report post Posted October 27, 2016 I aint been asked about a holster for the 629 .. and then three of them in the last couple ;months. Guess i better gitta dummy for that one .. Quote Share this post Link to post Share on other sites
wayner Report post Posted October 28, 2016 Hey jeff i will let you borrow my dummy gun for that if you want Quote Share this post Link to post Share on other sites
JLSleather Report post Posted November 4, 2016 On 10/28/2016 at 5:36 AM, wayner said: Hey jeff i will let you borrow my dummy gun for that if you want I found one - but thanks for the offer.. 'preciate ya! Quote Share this post Link to post Share on other sites
