Sanch Report post Posted April 5, 2017 Okay so here's my final attempt I don't think I'll be spending any more time trying to make these things I would say that this last attempt is passable the holes look good I ran some stitches through it as you can see they came out pretty good but after having tried a couple of times now I think I will just save some pennies and buy some or stick to my stitching awl. So if I am counting this correctly I ended up with 6 SPI which for me is fairly good. Anyway here are the end results the two prong is not quite up to par but I enjoyed having fun making Sparks. first pic is in process of making them the bolts is there for size reference. and here are some shots of the holes that they produce and a close up and a shot of the stitching. I did not catch the thread when I ran that Stitch. Quote Share this post Link to post Share on other sites
Mattsbagger Report post Posted April 6, 2017 Looks pretty good to me. How is the back side? Quote Share this post Link to post Share on other sites
Sanch Report post Posted April 6, 2017 (edited) 9 minutes ago, Mattsbagger said: Looks pretty good to me. How is the back side? The backside doesn't look bad at all considering that I did test it on an old 2x4 Edited April 6, 2017 by Sanch Quote Share this post Link to post Share on other sites
Bodean Report post Posted April 6, 2017 Looks like a winner to me. Quote Share this post Link to post Share on other sites
Sanch Report post Posted April 6, 2017 13 minutes ago, Bodean said: Looks like a winner to me. yup thanks Quote Share this post Link to post Share on other sites
William Bloke Report post Posted April 6, 2017 Looks like they make a nice consistent patten, and the steel looks chunky enough to hold up to a lot of use. Good job! Quote Share this post Link to post Share on other sites
