Members Brianm77 Posted May 9, 2017 Members Report Posted May 9, 2017 Si, I went into more detail in my first post. I was just pointing out that it sounds like it would work for this application quite well Quote
Members Colt W Knight Posted May 13, 2017 Members Report Posted May 13, 2017 (edited) I make GPS tracking collars out of this material, and I have punched thousands of holes in it. By far, the best way to punch holes is to chuck a sharp drive punch into a drill or better yet a drill press. If you use a cutting board or similar material as a bottom support, the bit will stay sharp for a very long time. Melting holes in this material will send out some nasty fumes, and you don't want to breathe them. Plus, if you are punching more than a few holes it is very inefficient. Punching the holes like traditional leather is tedious and dulls punches quickly Edited May 13, 2017 by Colt W Knight Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.