Members melancholycoyote Posted May 13, 2017 Members Report Posted May 13, 2017 About to get a well-maintained, working condition Singer 111w100 machine head! I was hoping to get some advice on how to get it up and going (needle size, thread size, etc.), as I haven't done a project like this before. I was looking at this particular servo motor: https://www.leathermachineco.com/product/brushless-digital-d-c-servo-motor/ but am open to recommendations! Any advice and help would be greatly appreciated. Quote
Members dikman Posted May 13, 2017 Members Report Posted May 13, 2017 The motor looks ok to me, only down side with an all-in-one unit is that to change settings you have to clamber under the table to get to the controls. Had to smile at the "600w bigger than 3/4 hp" bit. Technically, yes, it's bigger than 3/4 hp but the difference is so small you'd never notice it! Quote Machines wot I have - Singer 51W59; Singer 331K4; Seiko STH-8BLD; Pfaff 335; CB4500. Chinese shoe patcher; Singer 201K (old hand crank)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.