melancholycoyote Report post Posted May 13, 2017 About to get a well-maintained, working condition Singer 111w100 machine head! I was hoping to get some advice on how to get it up and going (needle size, thread size, etc.), as I haven't done a project like this before. I was looking at this particular servo motor: https://www.leathermachineco.com/product/brushless-digital-d-c-servo-motor/ but am open to recommendations! Any advice and help would be greatly appreciated. Quote Share this post Link to post Share on other sites
dikman Report post Posted May 13, 2017 The motor looks ok to me, only down side with an all-in-one unit is that to change settings you have to clamber under the table to get to the controls. Had to smile at the "600w bigger than 3/4 hp" bit. Technically, yes, it's bigger than 3/4 hp but the difference is so small you'd never notice it! Quote Share this post Link to post Share on other sites
