JerseyFirefighter Report post Posted June 8, 2017 So my Ferdco (juki clone) is normally kept at number 8 (I know this doesnt indicate stitch length), but it will no longer hold in reverse while stitching. It will drop back down to forward within a half revolution of the needle. It's looseness is evident when running forward at full speed with the lever slightly moving with each complete revolution of the needle. I was looking for a means to tighten it. The only place I see to potentially tighten nuts down is an access panel located directly behind the lever, however the wrenches included wont fit into such a confined space. Am I correct in looking to tighten the two nuts directly attached to the stitch length lever? I would much rather ask than trying to foolishly come up with a plan for a close quarter or offset wrench to tighten down on something. Your insight would be much appreciated. If more info is required I will gladly snap a few pictures. Thank you! Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted June 8, 2017 Look for this screw behind the back cover & tighten it just alittle. Quote Share this post Link to post Share on other sites
JerseyFirefighter Report post Posted June 8, 2017 3 hours ago, CowboyBob said: Look for this screw behind the back cover & tighten it just alittle. VERY much appreciated. I tried tightening at first and it seem snug already. Put a little more elbow grease on it and it's nice and smooth with lever placement. Thank you! Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted June 8, 2017 Your Welcome.Glad to know you got it fixed. Quote Share this post Link to post Share on other sites
