Is This Adler 167 Tension Assembly all Stock?

[AlexanderDyer]

I went to thread this Adler 167 GK 373 and I was stumped, I haven't seen anything like this and after several searches apparently the interweb hasn't either. I suspect this was a work around but have you seen one like this. Faced with needing parts I wonder what a good source might be in the US. Thanks for any thoughts and input.

 

[CowboyBob]

Yes,it original both the single & double needles use the same back plate but the tension post on a single needle is usually on the leftside.

Edited July 3, 2017 by CowboyBob

[AlexanderDyer]

Oh Sweet! So like this?

[CowboyBob]

If your machine was a double needle you would have 2-posts(with the tension discs),one on the right & one on the left,on single needles it's on the left & yours is on the right.It really doesn't matter as long as it's working,which it will but I was just letting you know.

[AlexanderDyer]

Thank you sir. I really appreciate your time and expertise.

[Uwe]

This is what a standard Adler 167 tension unit looks like:

[Uwe]

Then I found this, just like yours:

 

[Uwe]

Ha, the home-made looking double loop wire actually shows up in the Parts manual for the Adler 167-GK373:

 

 

The bottom end of your wire should be inside the corresponding hole in the plate, not sit on top of the plate.

 

 

Edited July 3, 2017 by Uwe

[CowboyBob]

 I was going by a machine we had on the shelf.

[AlexanderDyer]

Ah, yes. I see, this is much better. That spring has been riding there a good long time apparently, judging by the divot it has worn into the plate. Much appreciation.

[Pluimjr]

I have just the same machine, ADLER 167 - 73L

But I do the treathing (correct?) a little bit different.

 

[Rosch22]

Hi Leathermans,

reading this thread, I thought, may be someone out there does have what I'm looking for desperately:

I have got an old ADLER 167-373. Table, machine, belt and  all in actually good shape.

The only bitter pill with it: The whole tension plate (the ones we see in the pictures above) is missing!

Is there any gentleman out there who has a used one in the shelf somewhere and will give it away for an acceptable amount of money?

Would appreciate any offer!

Thx and hope to hear from You guys soon.

 

 

[Jryder]

Hello ...My Alder looks like the (standard) green one..can you tell me what the lever on the right is for,,,mine doesnt seem to do anything

Thank you