ivanlc Report post Posted December 19, 2017 I scribbled a note to myself to remind me of what I'd done to the leather workpiece I was tooling at the time. Sadly, it didn't occur to me to NOT write the note (or st least to not press down so hard) on the post-it note i used, pressing on the leather itself, and it's now left an imprint of what the note said, on the leather. (NOTE: no ink had been transferred to the leather; just the imprint of the pen's tip as it pressed down on the post-it.) Is there any (quick?) way to get rid of this...? Quote Share this post Link to post Share on other sites
Northmount Report post Posted December 20, 2017 Moisten slightly and carefully go over the impressions with a spoon. Be careful or you can leave more impressions you don't want. Tom Quote Share this post Link to post Share on other sites
ivanlc Report post Posted December 20, 2017 Which side of the spoon do I use and do I need to press down hard? What does this actually do wrt the leather?' Just want to understand how it works... Quote Share this post Link to post Share on other sites
Mattsbagger Report post Posted December 20, 2017 He is talking about a modeling spoon I believe. A regular kitchen spoon probably work. The smooth underside of the spoon rubbing on the leather might smooth out the writing. But if you push to hard it will leave a "dent" in the leather. Quote Share this post Link to post Share on other sites
ivanlc Report post Posted December 23, 2017 Hi guys. Just to jet you know that what worked in the end was simply moistening the area with water & massaging the indent with my (clean) thumb for a few minutes - gently to avoid any unexpected burnishing. I've then found that if I mix a solution out of Barkeeper's Friend (oxalic acid based cleaner), rub it on the hair side/front side of my pieces (diluting/spreading with a sponge that's sprayed with water, until the whole surface is the same greyish-pink colour) and then I wipe the surface over with jojoba oil, the subsequent dyeing procedure causes the dye to settle evenly across the surface. Thanks for your suggestions, chaps. Quote Share this post Link to post Share on other sites