Leerwerker Report post Posted July 11, 2018 I just acquired a Singer 29K60 Long arm big bobbin patcher today. The little motor runs and drives the machine! Most of my stitching is by hand or on my Tippman Boss. I have read all the threads about the 29K60 on this forum and made notes. So I hope my questions will be fairly few. I could not find a manual specific to the 29K60. Does anybody have a copy for me maybe in .pdf? I don't want to fiddle too much with the machine before making sure everything is where it should be.... The little motor has just about 12" of cord attached, and when you plug it in, it starts running. How are you supposed to start and stop the machine? Thanks! Johan Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted July 11, 2018 You were supposed to get a foot speed control pedal with the machine. Contact the seller about this. Otherwise, you will have to find a compatible electronic foot pedal that connects to the motor's power socket (between motor and AC source. The motor, floor pedal and double AC socket assemblies are usually sold as a package for about 50 bucks and up. Better motors and controllers can run you a hundred bucks and up. Quote Share this post Link to post Share on other sites
Wizcrafts Report post Posted July 11, 2018 The closest manual I found covers the Singer 29k62, which is the same generation machine. Get the manual here. Quote Share this post Link to post Share on other sites
Constabulary Report post Posted July 11, 2018 (edited) Can´t tell from the picture if the front drive shaft (for placing the hand wheel to the front side) is present. 29K60 is the large hook 29K62 the small hook variant. The 29K73 is very close to the 29K60 - just some minor differences. Singer 29K71, 29K72, 29K73.pdf Edited July 11, 2018 by Constabulary Quote Share this post Link to post Share on other sites
