JLSleather Report post Posted September 30, 2019 Anybody know how to read that crapra 4 manual? Messin' a bit.. don't usually use the "holster plate", since it's the same outside radius as the "regular" slotted plate, and don't use the "stirrup plate" because I can't be bothered to change the presser foot height and all that for the few projects that would benefit from that plate. BUT... I did give it a shot .. AGAIN. Now, the manual says put the lower feed back in, placing it 1/16" above the plate. Simple and clear. But manual also says put the shim in there (calling it the "inner race") with teh beveled edge "in toward the machine" and says "see below". But "below" doesn't exist, and the pic shown to the right (p 13) shows the OPPOSITE of what the text says (beveled edge is up). And on the opposing page, it shows the assembly with that "race" beveled edge OUT. So, WHICH is it SUPPOSED to be? [Note I ran the machine BOTH ways and did not note any significant difference either way] Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted September 30, 2019 Hey Jeff, Like the pic on the left,bevel towards inside. Quote Share this post Link to post Share on other sites
JLSleather Report post Posted September 30, 2019 'Preciatecha Bob! Yer my guy fer sewing machine 'stuff', but since I didn't purchase the machine with you I try not to abuse the privilege. Got any of that black thread layin around..... and I'll burn the town of your choosing I'd be glad to pay for some LL point needles in size #23. Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted October 1, 2019 Oh,yeah we have a lot of thread & we only have the LR point. Quote Share this post Link to post Share on other sites
