KennethM Report post Posted December 28, 2019 Hey brothers and sisters .I have a question.I have the generic small letter stamps you get from Michael's or hobby lobby. I was looking for a holder or something to put multiple letters into so I can have the spacing good and have words come out straight and not jagged lol I was looking on Etsy but they are really pricey. Had anyone created a simple jig for this and if so would you mind helping me?! -Ken Quote Share this post Link to post Share on other sites
Handstitched Report post Posted December 28, 2019 G'Day, I normally align them by sight with a ruler and some planning, but this may help. https://leatherworker.net/forum/topic/60980-best-way-to-align-letter-stamps/ HS Quote Share this post Link to post Share on other sites
fredk Report post Posted December 28, 2019 I also have this jig. Its made of 4 pieces of 3mm thick clear acrylic. Three bolts are not full tightened, the one on top right is a wing nut, or butterfly nut. Loosen that to pull the four pieces of acrylic to the size of the letter stamps - in the picture they are 1/2 inch size. Tighten the wingnut and its all solid. Quote Share this post Link to post Share on other sites
KennethM Report post Posted December 29, 2019 15 hours ago, fredk said: I also have this jig. Its made of 4 pieces of 3mm thick clear acrylic. Three bolts are not full tightened, the one on top right is a wing nut, or butterfly nut. Loosen that to pull the four pieces of acrylic to the size of the letter stamps - in the picture they are 1/2 inch size. Tighten the wingnut and its all solid. Thank you Quote Share this post Link to post Share on other sites
