Members sinpac Posted February 10, 2020 Members Report Posted February 10, 2020 (edited) I made this Push Beveler out of a C.S. Osborne #3 single edge creaser. Didn't turn out to bad. 2 minutes ago, sinpac said: Edited February 10, 2020 by sinpac Quote
Contributing Member Bob Blea Posted February 13, 2020 Contributing Member Report Posted February 13, 2020 Nice work! You got a good finish on the face of that beveller. Quote
Members YinTx Posted February 14, 2020 Members Report Posted February 14, 2020 Must... resist... urge... Must... hide.... creasers.... Seriously though, nicely done. Now I'll have to find one of my Gomph creasers and start to grinding... or maybe I'll find a cheaper version on Ebay... YinTx Quote
Members sinpac Posted February 14, 2020 Author Members Report Posted February 14, 2020 23 hours ago, Bob Blea said: Nice work! You got a good finish on the face of that beveller. Thank you Sir. 18 hours ago, YinTx said: Must... resist... urge... Must... hide.... creasers.... Seriously though, nicely done. Now I'll have to find one of my Gomph creasers and start to grinding... or maybe I'll find a cheaper version on Ebay... YinTx I used files on mine. I use mine on borders everything else done with beveler and maul. Quote
Members YinTx Posted February 14, 2020 Members Report Posted February 14, 2020 12 minutes ago, sinpac said: I used files on mine. I use mine on borders everything else done with beveler and maul. I suspect I'll be trying this in the near future. I have a push beader and I really like it, a swivel beveler and it is ok, been wanting to try out a push beveler and this may be a way to do it! YinTx Quote
Members sinpac Posted February 14, 2020 Author Members Report Posted February 14, 2020 Just now, YinTx said: I suspect I'll be trying this in the near future. I have a push beader and I really like it, a swivel beveler and it is ok, been wanting to try out a push beveler and this may be a way to do it! YinTx The new Osborne push beveler may be fine, but I cant find a picture of the profile. Another tool maker is selling them for 55 dollars plus 10 dollar shipping. I had two #3 single edge creasers. So I figured WTH give it a go. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.