DaveP Report post Posted August 1, 2020 (edited) Trying to practice a new basketweave stamp. I've not done this before. I would like to put something like this on my small knife sheaths. Thoughts? Thanks again, Dave Edited August 4, 2020 by Northmount corrected title Quote Share this post Link to post Share on other sites
OLESKIVER Report post Posted August 2, 2020 ok, I am guessing that the sheath you have traced out is about the size you will be making? the first thing that comes to my attention is the irregular inside border, I would think you would want it about the same size as the front of the sheath, all the way around. and so saying you want to pick stamps that are proportional to what you are putting them on. It looks like to me that your border tool is a little too big, plus you want them alot closer to each other, touching actually. I think you did a good job on the basketweave tool, hopefully you did scribe a line in the middle of the sheath for a starting point for your stamp. maybe scribing an inside border would also help keep it a bit more orderly. over all it is not a bad job, you might also toy with the idea of a smaller basketweave tool. personally I don't see why it wouldn't work. hopefully I understood the question properly. hope this helped. Quote Share this post Link to post Share on other sites
AzShooter Report post Posted August 2, 2020 I like that stamp. You di d very well at getting it deep enough. I agree that your edge stamp needs to be closer together. If you were trying to space them evenly so that they made the entire length of the line that's o.k. but you only need to space a few not the entire line. Quote Share this post Link to post Share on other sites
DaveP Report post Posted August 2, 2020 Thanks for the help! After reading these I will put the boarder closer. It's the only one I have. The lines were just free handed. On a real project I would use divider to make it right. I did scribe a line for starting point. Thanks again Quote Share this post Link to post Share on other sites
DaveP Report post Posted August 2, 2020 Question... Would you take the basketweave pattern all the way around to the back side as well? Quote Share this post Link to post Share on other sites
chuck123wapati Report post Posted August 2, 2020 (edited) 1 hour ago, DaveP said: Question... Would you take the basketweave pattern all the way around to the back side as well? I don't but that's me, I go to the center of the bend with my patterns. One thing you will find is your stamping will be lost a bit when you bend the leather so wrapping it completely around might not look the way you want it to. Bend your test piece to see what happens. Cool lil skinner there! Edited August 2, 2020 by chuck123wapati Quote Share this post Link to post Share on other sites
DaveP Report post Posted August 4, 2020 (edited) Picked up a couple smaller stamps. These are from the Tandy store. The other basket stamp is a Berry King. Wanted a stamp now so drove over the Tandy store... 25 minutes away and open. Tried it again. It's not perfect but it's a beginning. I think this smaller size is harder to use. What do you think of this one? Edited August 4, 2020 by DaveP Quote Share this post Link to post Share on other sites
AzShooter Report post Posted August 4, 2020 Much better job. Nice depth and great edges. Quote Share this post Link to post Share on other sites
chuck123wapati Report post Posted August 4, 2020 the smaller stamp looks better, as well the border is much better. Quote Share this post Link to post Share on other sites
DaveP Report post Posted August 4, 2020 Thanks for the praise. It still needs some finess. Quote Share this post Link to post Share on other sites
