First IWB Revolver Holster S&W 642 - video - pattern

[BentleyLeather]

Hey Everyone, 

I just uploaded a new video where I make an IWB holster for a S&W model 642. I'm not a holster maker but I have put a few together for myself to conceal carry and training/range. It's not so much a tutorial as a general demonstration for those attempting this with hand tools.

I did make a "rough draft" pattern and have included it as well for free (see it in the video description). I would modify it in the future to sit a bit lower. The pattern is slightly too long so it could handle lowering the gun 1/4" as is. I would have used snaps, but I did not have any handy that would work with such thick leather. Also I would like to try resolene as a finish but none on hand either. Instead I used burnishing agent on the inside and boot wax outside. The few holsters I have made seem to do just fine with the same finish. 

I may try to find some metal clips for future holsters. Especially if there is one that could reach from inside the pants and go over the belt?

Anyways feel free to let me know what you think and I appreciate the support. 

-Bryan 

 

[Simplejack1985]

Your a life saver. I've been looking for a iwb pattern for my wifes 442. 

[BentleyLeather]

On 8/22/2020 at 2:36 PM, Simplejack1985 said:

Your a life saver. I've been looking for a iwb pattern for my wifes 442. 

I hope that helps! Feel free to share how it turns out. I would adjust the stitching so it fits a bit deeper in the holster. There is enough leather to get it 1/4”-3/8” deeper. A metal clip would also be an easier option than the belt loop. I’ve carried this a few times now in the appendix position and it works pretty well.