KennethM Report post Posted August 30, 2020 What's up guys I have a cobra class 26. I always have issuies on curves to get my knot centered. I think it's just human error and not tension. I burry the needle dead bottom then come up just a hair. Sometimes it looks right and sometimes it does, sometimes it's a random knot showing Quote Share this post Link to post Share on other sites
Constabulary Report post Posted August 30, 2020 (edited) I make turns when the needle is further up and the hook has caught the thread loop. Open the slide plate / hook cover and hand crank your machine and check where the hook tip is when you make the turn. Edited August 30, 2020 by Constabulary Quote Share this post Link to post Share on other sites
Northmount Report post Posted August 30, 2020 Also don't lift the foot too high or it will release your top tension. Tom Quote Share this post Link to post Share on other sites
KennethM Report post Posted August 31, 2020 I'll try bringing the needle higher and seeing what happens.it was working fine then just having some bad luck Quote Share this post Link to post Share on other sites
